Each waterproof TYPE C connector has an IP parameter during the production process, that is, the waterproof and dustproof level. The higher the value, the more waterproof it is. When producing such products, USB connector manufacturers will use a sampling method to test the waterproof level and air tightness of the product to determine its IP parameters. At this stage, the waterproof air tightness test tool for the waterproof C-type connector is an air tightness tester, and the specific test method steps are as follows.

The waterproof test water depth is determined according to the IP value designed for the waterproof TYPE C connector. For example, the IP67 standard test water depth should be 1 meter and the pressure should be around 10kPa, but in actual tests, the pressure will be appropriately increased to 15kPa. The specific test steps are: put the waterproof C-type connector to be tested into the fixture, press the start button, the cylinder automatically presses down, tightens the sealing ring, seals the side cylinder, and then starts the air tightness tester. The instrument will automatically test according to the set parameters. When the test time is over, the screen will display the leakage value of the tested product, and the alarm indicator will indicate whether it is qualified. After the test, the cylinder automatically rises and the operator takes out the product.

Waterproof TYPE C6pin vertical waterproof connector

When testing the waterproof TYPE C connector, the relevant Chinese standards should be followed to ensure that the leakage is no more than 0.05kpa. The air intake time is 2S, the voltage stabilization time is 2S, the test time is 5S, the exhaust time is 1S, and the overall test time is controlled within 10S. If the detected leakage value exceeds the standard, the alarm indicator of the air tightness tester will light up, indicating that the product of the USB connector manufacturer is unqualified. When the waterproof test pass rate is lower than the standard requirements, the manufacturer needs to re-check the structural design and production process of the waterproof-c type connector to further improve the waterproof and air tightness of the product.

Waterproof TYPE C16P board waterproof connector

The waterproof TYPE C connector has the following characteristics:

1. The power supply can provide a variety of voltage and current specifications, up to 100W.

2. Symmetrical connection, positive and negative connection, can withstand 10,000 repeated plugging and unplugging.

3. High bandwidth, data transmission speed can reach 10gbit/s, rated current 3A~5A.

4. Flexible channel configuration, such as interface insertion direction, interface power supply function, Atermatc mode and peripheral mode.

5. Through the waterproof TYPE C connector, support non-USB signal transmission and various OEM product customization methods.

6. Compatibility, the USB switch can be connected to different types of interfaces.

7. Small size, thinner than type A and type B, can greatly reduce the size of electronic products.

Waterproof TYPE C double-row SMT waterproof mother seat

The waterproof TYPE C waterproof connector is a USB connector with a certain waterproof function. Since 2014, the USB-IF Association has developed a new generation of interfaces to meet the challenges of higher speed interfaces. After the launch of the waterproof TYPE C connector, it has attracted the attention of the industry. Industry professionals believe that this new interface will bring a new electronic connection mode.